Payment & Shipping Terms:
|Plasticizing Way:||Screw Type||Clamping Way:||Hydraulic & Mechanical|
|Automation:||Automatic||Transport Package:||Export Standard Packing|
|HS Code:||8477101090||Clamping Force:||1800KN|
all electric injection molding machines,
plastic products making machine
Die positioning hole diameter 80~100 125~250 315 or more
Coaxiality of nozzle and positioning hole of die is less than 0.25 less than 0.30 less than 0.40
(1) This project should be carried out after the horizontal and vertical adjustment of the template and fuselage.
(2) Loosen the fastening bolts connecting the front and rear brackets of the injection seat guide rod with the fuselage; Loosen the locking nuts on the horizontal adjustment bolts on both sides of the guide rod front bracket. (Micro-injection molding is the largest Wechat public number in the injection industry. Welcome to our attention)
(3) Measure 4 points in circumference with vernier calipers of accuracy over 0.05mm, h1, h2, H3 and h4, adjust the bolts horizontally to make H1 = h3, and adjust the bolts up and down of the guide rod bracket to make h2 = h4, as shown in Figure 9-4. The adjustment error is controlled according to the tolerance given in the table above. Measuring the clearance between the inner hole at the tail of the barrel and the screw with a plug ruler makes delta 1 = delta 3 and delta 2 = Delta 4, as shown in Fig. 9-5. The level of the guide rod of the launching platform should be measured by the level meter, as shown in Fig. 9-6. After adjustment, tighten the fastening bolts on the front and rear guide rod brackets and the locking nuts on both sides of the front support respectively.
Contact Person: Rayson